Celestron Cosmos 60AZ Bedienerhandbuch PDF herunterladen (Seite 4)

4 | ENGLISH

60AZ TEL ESCOPE

the eYePieceS

Your telescope comes with two eyepieces, a low power (20 mm eyepiece) and a higher power eyepiece (10 mm

eyepiece). Whenever you set up your telescope, always start with the 20 mm eyepiece. Once you have your target

centered in the 20 mm eyepiece, you can switch to your higher power 10 mm eyepiece to get a more detailed view.

Note that because your telescope is designed for astronomical use, images of terrestrial objects will appear mirror-

reversed. This is perfectly normal.

To install an eyepiece:

1. Loosen the setscrews on the open end of the star diagonal.

2. Insert the silver barrel of the 20 mm eyepiece into the star

diagonal.

3. Tighten the setscrews to secure the eyepiece

4. To see the sharpest image possible, you need to focus by

looking through the eyepiece and slowly turning the focusing

knobs until you ﬁ nd the sharpest image.

the FinDerScoPe

The 60AZ comes with a ﬁ nderscope that you will use as a sighting tool when aiming the telescope at a distant target.

The ﬁ nderscope is permanently attached to the telescope tube, but you need to install its CR1620 battery:

1. Make sure that the knob securing the telescope tube is fully tightened.

2. Rotate the knob at the end of the panning handle to allow the mount to move up and down easily. Point the scope

downward and retighten the handle.

3. Use the included ﬂ at triangular slotted screwdriver tool to open the battery compartment. Insert the tool into the slot

on the battery cover and turn it counterclockwise.

4. Insert the battery into the compartment with the positive (+) side facing up.

5. Replace the battery cover using the screwdriver tool.

6. Loosen the panning handle knob, straighten the telescope so it is level, and tighten the handle to secure.

Fig. 5

Fig. 4

1 2 3 4 5 6 7 8 9 ... 39 40

Keine Kommentare

Celestron Cosmos 60AZ Bedienerhandbuch Seite 4